  |
   |
|
|
 |
 |
 |
 |
|
|
|
|
 |
| SmartLink™ | |
| Electrical | |
| Operating Voltage Range: | 105 - 135 Vac, 60 Hz |
| Surge Withstand: | ANSI C62.41 - 1987 |
| Electrostatic Discharge Test: | IEC 801-2, 15 kV |
| Power Consumption: | Less than 5 watts |
| FCC: | Compliant |
| Output Relay (switch control): | |
| Number:
Type: Maximum load: Maximum Inrush: Contact closure period: Option 1: Option 2: |
Two Momentary closure Normally open 10 amps 120 Vac, 60 Hz, 50 A, 50% PF, 6 Cycles, Make Only 1-255 seconds, in 1 sec increments Two 120 Vac NO switched contacts Two SPST, NO isolated contact sets |
| Fuse
Rating: |
|
| Controller
power/output to switch: Battery circuit: |
10A
FNM Slo-Blo 3A |
|
Status Monitoring/Control: |
|
|
Status Inputs: |
5 opto-isolated
inputs mutually isolated from each other, line and neutral(customer wetted 40V - 140V ac or dc) or 2 dry contact inputs, internally wetted with 12Vdc, 2.5 ma with common terminal, isolated from line, neutral, chassis. 2 status outputs (solid state and isolated from each other, line and neutral) or 2 relay outputs as described in the Output Relay section above |
|
Communications: |
|
|
RS232 Communications
port: |
DB9 female connector |
| Fault
Indicator Receiver (Cap Control N/A): |
|
| Operating
Frequency: Receiver Range: Certification: |
312 MHz 100 feet typical (used with model 1548 FCI) Complies with FCC Part 15 emissions |
| Environmental | |
|
Ambient Temperature Range: |
-30°C to +55°C (outside) |
|
Humidity Range: |
0 to 95% (non-condensing) |
| Measurement
Performance Voltage, True RMS: |
|
| Secondary | |
|
Resolution: Accuracy: |
0.2
Vac ± 0.8% of reading |
| Mechanical | |
| Enclosure:
|
NEMA 3R, Lexan or Aluminum |
| Security: | Latch suitable for meter seal and padlock |
| Mounting:
|
4
or 6 stab meter base (Lexan or Aluminum) Wall or pole bracket (Aluminum) |
| LED Indicators: | |
| Red:
Red: Red: Green: Red: |
Processor
OK Cellular communications present indicator Close Trip (open) Faulted circuit indicator (FCI) |
| Panel Switches: | For remote/local and manual switch operation |
| External Antenna: | Top Mounted Cellular antenna and FCI antenna |
| Dimensions: | 8.5"h
x 6.5"w x 4.75"d (Lexan) 11.5"h x 7.0"w x 4.0"d (Aluminum) |
| Weight: | 5 lbs
nominal 11 lbs Solar powered |
| Battery: | |
| Standard:
Solar: |
Nickel
cadmium rechargeable 10.8Vdc Solid lead acid 12V, 2.5Ah |
|
Home | About Us | Products | Library | Contact Us | Chinese Site Joslyn Hi-Voltage - 4000 E 116th Street, Cleveland, Ohio 44105 USA Email: T&B Contact InformationCopyright © 2001 Joslyn Hi-Voltage. All rights reserved. |
